Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Apr 25, 2010 20:06:03 GMT
Has anybody seen or considered a bench seat for their RV? My RV is nearing completion but I need a decent size back end for load lugging but at the same time need it to be a 3 seater on occasions.
Anybody got any ideas?
|
|
|
Post by terryrob on Apr 25, 2010 22:57:51 GMT
I thought about a bench seat a while back. The main concerns were that the handbrake would have to be re located and it would all have to tilt forward to get in to the back. That aside it would look cool.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Apr 26, 2010 18:21:45 GMT
I thought about a bench seat a while back. The main concerns were that the handbrake would have to be re located and it would all have to tilt forward to get in to the back. That aside it would look cool. Cheers Terry ;D I have the advantage of opening rear tailgate, (Upper and lower), which solves the access issue. Thinking about Ford P100 under dash handbrake and bench seat. Need to find a P100 to measure up and investigate further...can't even remember the last time I saw one though!!
|
|
|
Post by terryrob on Apr 26, 2010 19:22:46 GMT
Good luck mate, it will be great if you can work it out
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Apr 27, 2010 22:53:50 GMT
theres always some on ebay for a couple of hundred quid! You can get the sierra dash as well then !
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Apr 28, 2010 18:17:49 GMT
theres always some on ebay for a couple of hundred quid! You can get the sierra dash as well then ! I've got a Sierra dash in from a 4x4 Ghia.....more flashiong lights than Christmas!!!!! Looked into it a little more....would need to be a Cortina P100 as the sierra version had individual seats. Gearbox/prop tunnel is an issue as ideally you'd want a flat floor for the central seat....dont want the youngster booting it out of gear Go back to the drawing board methinks...but a huge pain if it is only a 2 seater
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Apr 28, 2010 20:46:59 GMT
I will look at a Multipla > and measure against our Rv > may fit. expecially if you still got seat boxes
and I am dismantling a Sierra If any parts required just ask
|
|